Bug in 2.4.2?

[EFI-Unlimited]

I recently upgraded to 2.4.2 and I think I may have found a bug. If I select 'reload tool table' under the file menu, my tool selection, and cutter comp quit working. Down on the bottom of the screen where it normally would list a tool diameter and number, it just says 'no tool' and I can't do anything to change it, unless I restart EMC.

Can/has anyone else been able to duplicate this?

Brian

[chester88]

You need to post this on the emc mail list.

https://lists.sourceforge.net/lists/listinfo/emc-users

not many developers read the 'Zone